The cleaning procedure using the cleaning kit is as follows:
 |
Never use organic solvents, such as thinner and benzine to clean the product. |
 |
For details on the cleaning kit, refer to the manual attached to the cleaning kit. |
View the video below for the procedure.
|
1.
|
Make sure that the product is powered off, and disconnect the power cord from the AC outlet.
|
|
|
|
•
|
Open the top cover fully to prevent accidental drop of the cover.
|
|
|
3.
|
Push the head lock lever (1) towards the rear to unlock the print head.
|
|
|
|
•
|
The print head and its surroundings are hot after printing. Be careful not to get burned.
|
|
•
|
Touching the edge of the print head with your bare hand could cause injury.
|
|
|
4.
|
Remove the media and ribbon if they are already loaded.
|
|
5.
|
Clean the dirt on the print head (2), platen roller (3) and ribbon roller (4) using a cotton swab dabbed with cleaning liquid.
|
|
6.
|
Tilt the sensor guide lock (5) down and pull out the media sensor guide (6).
|
|
7.
|
Clean the bottom of the media sensor guide using the cotton cloth dabbed with cleaning liquid.
|
|
8.
|
Clean the media sensor (7) using the cotton cloth dabbed with cleaning liquid.
|
|
9.
|
Return the media sensor guide to its original position and tilt the sensor guide lock up to the locked position.
|
Comments
0 comments
Please sign in to leave a comment.